13
After this, you can make another espresso.
Caution: during and after use of the
machine, the metallic parts of the steam
nozzle can become burning hot.
. Using the Krups Auto Cappuccino
accessory (model FNC3 only)
The Auto-Cappuccino accessory makes it easy
to produce frothy milk for making
cappuccinos, lattes and hot chocolates.
The milk is drawn in through the flexible
tube and heated with the aid of steam
before coming out via the outlet nozzle
of the auto cappuccino accessory.
If the flexible tube is immersed directly in a
carton of milk, a single cup is enough to
prepare a cappuccino or a latte. You can
adjust the amount of froth of the milk by
using the dial of this auto cappuccino
accessory.
It is best to use fresh, skim or low-fat milk, not
boiled, and well chilled (kept in the
refrigerator). The container must also be cold
(do not run it under hot water before frothing
the milk).
For heating thick liquids, please refer to the
section “Heating thick liquids (e.g. soup)”
We recommend that you clean the auto
cappuccino accessory immediately after use -
please refer to section “Cleaning the
Machine”.
If you are making a cappuccino or latte, you
will need at least a 5 oz. cup (150 ml).
Cappuccino is made using 1/3 espresso, 1/3
hot steamed milk and 1/3 frothed milk. Café
latte is made using 1/2 espresso, 1/2 steamed
milk, and topped with a bit of frothy milk.
• Fill the water container with fresh, cold
water (1) (2) (3) and turn on the appliance
(5).
• Move the nozzle to the exterior of the
appliance and mount the auto cappuccino
accessory on the nozzle (22).
• Turn the dial to the
setting (23).
• Immerse the flexible tube in the milk to be
heated (you can use the Krups container or
any other container) (24).
Once the appliance reaches the right
temperature, the orange temperature control
light will go out.
• Hold the container under the steam nozzle
equipped with the cappuccino accessory in
such a way that the tip is immersed in the
milk.
• Turn the selector to the
setting (26).
Keep the container straight during this
operation. Do not allow the tip of the
nozzle to touch the bottom of the container
because this could obstruct the steam
output.
• Once you have obtained the desired
quantity of frothy milk, turn the selector to
the O setting.
• After use, remove the flexible tube from the
container and clean the auto cappuccino
accessory (see section “Cleaning the
Machine”).
. Preparing hot, steamed milk for a cafe
latte, hot chocolate or for heating water
(for tea, for example).
Notes:
. Hot chocolate: immerse the flexible tube
directly into the carton if the chocolate milk is
ready-made, or heat the milk if you are using
powdered chocolate. Then mix the powder in
the heated milk.
• Move the nozzle to the exterior of the
appliance and mount the auto cappuccino
accessory on the nozzle (19).
• Fill the water container (1) (2) (3) and turn
on the appliance (5).
• Turn the selector to the setting (20) .
• Turn the dial of the auto cappuccino
accessory to the fine end of the setting
scale (27).
• Immerse the flexible tube in the liquid to be
heated. The tube must touch the bottom of
the container.
• Place a container under the outlet nozzle.
Once the appliance reaches the right
temperature, the orange temperature control
light will go out.
• Turn the selector to the steam setting
(21).
• Once you have obtained the desired
quantity of frothy milk, turn the selector to
the O setting.
To Next Page
Loading...
Need help?
General
