14
• After use, remove the flexible tube from the
container.
. Using the Krups patented Perfect Froth
Attachment
Krups patented Perfect Froth attachment Is
available on all models. For the FNC3 model
you will need to remove the auto-cappuccino
attachment and replace It by the Perfect Froth
Attachment in order to execute this operation
(36).
You can use the Perfect Froth attachment to
froth milk for cappuccinos, Lattes and hot
chocolates as well as heating any liquid (water
for tea or thick liquids for soups)
• Fill the water container (1) (2) (3) and start
the appliance (5).
• Move the steam nozzle to the exterior of the
appliance.
• Turn the selector to the setting
(20).
Once the appliance reaches the correct
temperature, the orange temperature control
light will go out.
• Immerse the steam nozzle in the container
holding the liquid to be heated.
• Then turn the selector to the
setting (21)
until the liquid is hot enough, then reset the
selector to the O setting and remove the
container.
• For liquids other than water, turn the
selector to the setting
(20) for the
following cleaning operation in order to
prevent any blockage of the opening of the
steam nozzle :
• place an empty container below the steam
nozzle.
• select the
setting again (21) to remove
the residue of the liquid.
• turn the selector to the setting O.
• Clean the steam nozzle with a damp cloth.
• For more thorough cleaning of the nozzle,
please refer to the paragraph on
maintenance.
Cleaning the Machine
- Never wash your espresso machine
accessories in the dishwasher.
After use, the water container must be
emptied.
. Removable drip tray
After using the appliance, remove the
overflow grid and empty the removable drip
tray (30) (31). If several espressos are being
prepared one after the other, the drip tray
should be emptied from time to time (about
once every 7 - 8 espressos). If necessary, clean
the drip tray and its grid with water and a
little non-abrasive dishwashing liquid, rinse
and dry. When reassembling the machine,
ensure that the plastic lining is in the right
place (32).
. The brewing head, the filter basket and
the filter holder
These must be cleaned after each use. All you
need to do is wipe a damp cloth over the
brewing head of your appliance and to wash
the other accessories in water and a little non-
abrasive dishwashing liquid, rinse and dry.
If the brewing head is heavily clogged up,
unscrew the grid using a coin, clean it and
refit it, pressing down firmly (33).
When your espresso machine is not being
used, do not leave the filter holder in the
appliance to prevent wear on the gasket.
. The cup warming plate: remove this to
clean it with water and a little non-abrasive
dishwashing liquid, rinse and dry (34).
. Steam nozzle: wipe with a damp cloth after
each use.
. The auto cappuccino accessory
After each use, we recommend that you rinse
the auto cappuccino accessory in the
following manner:
• Turn the selector to the steam pre-heating
position
(19).
• Turn the dial to the cleaning position (37).
• Immerse the flexible tube into a glass of
water. (The minimum quantity necessary is 3
to 4 ounces/30-60 ml).
• Place an empty container below the outlet
nozzle.
Once the appliance reaches the correct
temperature, the orange temperature control
light will go out.
• Then turn the selector to the steam setting
(26).
• When all the water has run through the
To Next Page
Loading...
Need help?
General
