11
The coffee machine will automatically shut off after 1 hour if not used.
You can interrupt the brewing cycle by pushing the brew button. The brewing will stop and go
directly to the steam phase (purge). The brew indicator light will steady at the end of this phase.
If, during the brewing, you stop your machine by pressing the on /off button (M), your coffee
machine will stop. You will not have a steam (purge). Wait two minutes before opening the brew
head.
Immediately clean the spray heads and the seals using a damp cloth, then thoroughly wash
the pod holders.
If you change the volume during brewing by turning the selector (P) the new volume will be
used.
Particular attention for the use of the « specialty » pod holders (I)
Before use :
The « specialty » pod holders are equipped with a removable nozzle.
The removable nozzle provides a creamy foam finish on top of the cappuccino or latte drinks.
Before use, check that they are not clogged.
It is important to keep these nozzles clean and free of any sediment to prevent clogging.
Rinse with warm water after each use. Periodically or if clogged, remove the nozzle more
thoroughly clean.
To remove the nozzles :
• Push the tip of the nozzle from the bottom.
• Pull the nozzle out from inside the pod holder.
• If the small holes are blocked, unblock them by using a fine needle.
• Run under hot water.
• Ensure that the 2 gaskets are in place.
• Reinsert the nozzle into the pod holder from the top.
• The nozzle is correctly in place when the end of the nozzle is visable
from the end of the exit tube on the pod holder.
To Next Page
Loading...
Need help?
General
