Krups NESCAFE DOLCE GUSTO MINI ME - Preparing a Beverage

9
EN
PREPARING A BEVERAGE
STOP
Set the beverage volume with the selector fol-
lowing the recommendation indicated on the
capsule, or set it to your own taste.
Take cup from drip tray. Open locking handle.
Adjustdriptraypositionaccordingtothe
chosen beverage (see page 6-7). Place cup on
drip tray.
Move the lever to the right for hot beverages
and to the left for cold beverages. Beverage
preparation starts. Wait until the lever comes
back to the middle and extraction stops.
Extraction can be stopped manually by moving
the lever back to the middle position.
Pull out capsule holder and remove used
capsule. Put used capsule in dustbin.
Open locking handle and pull out capsule
holder. Insert capsule in capsule holder and
insert it back in machine. Close locking handle.
Afternishingpreparationthepowerbutton
blinks red for about 10 seconds. During that
time do not open locking handle!
Rinse both sides of the capsule holder with
water and dry. Insert capsule holder into ma-
chine.Enjoyyourbeverage!
Switch machine on. Power button starts blink-
ing red while machine is heating up. This takes
approx. 30 seconds. When the power button
light is steady green, the machine is ready.
30 sec
10 sec
1
4
7
2
5
8
3
6
9
ON
1
2
3
1
2
3