Krups XP2280 User Manual

English
12
n Press the button (fig.4).
n Once the LED becomes steady, turn the knob to position and let 100 ml of water flow through
the nozzle and then turn it back to "0" position
n The appliance is descaled and ready to be used again.
Espresso
Espresso
6. TROUBLESHOOTING
Problems Possible causes Solutions
The espresso is not
hot enough.
The cups and the filter
holder are cold.
Preheat the accessories: cups and filter holder
(see paragraph 6).
The LED and
the pictograms
and flash and
the appliance does
not work.
Espresso
The knob has been turned
to the position.
Turn the knob to the “0” position (fig.15).
The filter holder is
blocked
You forgot to unlock the
filter.
Press the "OPEN" button lightly while turning the
filter holder to the left.
The grounds are not
dry after water has
run through.
You have not tightened the
filter holder properly.
Tighten the filter holder further by turning it to the
right as far as possible, up to the stop.
The espresso flows
too slowly.
The espresso ground coffee
is too fine, too oily or floury.
The flow rate depends on
the fineness of the coffee
used and can vary when
preparing the espresso
The filter holder is dirty.
The water drip-through grid
is clogged.The water drip-
through grid is clogged.
Choose a slightly coarser espresso ground
coffee
Clean your filter holder (see paragraph 4).
When the appliance has cooled, clean the
brewing head with a damp cloth. (fig.21).
The water does not
run through.
No water in the tank.
Tank poorly fitted.
The filter is clogged. The
espresso ground coffee is
too fine.
Your device is scaled up.
The Claris cartridge has
been replaced but not
primed.
Fill the tank.
Press down firmly on the tank.
Clean the filter holder (see paragraph 4) and try a
less fine espresso grind.
See paragraph 5.
See paragraph 1
Water leaks from
the filter holder after
an espresso has
been made.
Premature formation of
scale due to especially hard
water.
Descale your appliance according to the manual
(see paragraph 5).
Coffee grounds in
the cup.
The filter holder is clogged.
The grind is too fine.
Clean the filter holder with hot water. Press
“EJECT” to eliminate the remnants of the
grounds. Shake to drain the water.
Use a slightly coarser espresso grind.
KR_XP2280_NAFTA_NC00026071-01 17/11/11 17:55 Page12

Krups XP2280 Specifications

General

Brand	Krups
Model	XP2280
Category	Coffee Maker
Language	English