English
11
11. END-OF-LIFE ELECTRONIC PRODUCT
Environmental protection first!
Your appliance contains a lot of recoverable or recyclable material.
When disposing of it, take it to a local civic waste collection point.
The machine leaks
on the sides of the
filter holder.
The filter holder has not
been properly positioned.
The edge of the filter holder
is clogged by ground coffee.
Pod poorly positioned in the
filter.
Put the filter holder in place and lock it (by turning
it to the right as far as it will go, up to the stop).
Remove excess coffee.
Place all the paper inside the filter holder.
Your espresso tastes
bad.
After descaling, the rinsing
was not performed properly.
Rinse the device according to the manual (see
paragraph 9).
The appliance does
not work
The pump was unprimed
due to lack of water.
The detachable water tank is
not properly clicked in place.
The Claris cartridge has
been replaced but not
primed.
Fill the water tank and reprime the pump (see
paragraph 5). Avoid completely emptying the tank.
Click the tank into place by pressing firmly.
See paragraph 5.
The steam nozzle
does not froth the
milk.
The steam nozzle is clogged
or scaled up.
The milk is not cold or not
fresh enough.
The shape of the container
is not appropriate.
Descale the steam nozzle (see paragraph 9) or
unclog it with a needle.
Use fresh, cold milk. Try using a different brand of
milk.
Use a small pitcher.
Problems Possible causes Solutions
Crackles are heard
in the filter holder.
Normal phenomenon:
the filter holder security lock.
The pump is
unusually noisy.
No water in the tank.
Tank not locked in place.
Stop the appliance, fill the water tank and turn the
machine back on.
Press down firmly on the tank.
The cups are not
filled equally.
The filter holder is clogged. See paragraph 8.
KR_ESPRESSO_XP56_NAFTA_8080012562_808001256210/04/1315:16Page11
To Next Page
Loading...
Need help?
General
