English
5
- RINSING OUT THE STEAM CIRCUIT.
Before using the steam function for the first time, the steam circuit should be cleaned.
n Fill the water tank
n Turn the appliance on by pressing the button.
n Place a recipient underneath the steam nozzle.
n Turn the switch to the position, the button starts to blink.
n When the button has stopped flashing, turn the switch to the position and let the water run until
steam is formed.
n Keep the steam production going for at least 30 seconds.
In order to release all the aromas of the coffee and ensure your complete satisfaction, this machine pre-
infuses each coffee. The pump works for 3 seconds, stops the following 3 seconds and then the cycle
continues until the end of the preparation.
PREHEATING THE ACCESSORIES
For the best results, we recommend that you preheat the accessories (filter holder and cups) without
espresso ground coffee. To do so:
n Fill the water tank and turn the machine on. (fig.1, 2, 3 and 4).
n Put the filter holder in place, place the cups underneath the filter holder.
As soon as the appliance reaches the required temperature, the light stops flashing.
n Turn the switch to the " " position (fig.8).
n When the cups are filled with hot water, turn the switch to the " " position. (fig.9).
n Remove the cups.
n Unlock the filter holder: press "OPEN" while turning the filter holder to the left and remove it from the
machine. (fig.10).
Note: When the appliance is hot, the espresso cups can be preheated on the cup warming plate.
WITH GROUND COFFEE
The type of coffee you choose will determine the strength and taste of your espresso. Always
use espresso ground coffee. Do not use instant coffee.
n Fill the water tank and turn the machine on (fig. 1, 2, 3 and 4). During the preheating of the appliance,
the light flashes.
n Using the measuring spoon, place the espresso ground coffee in the filter holder: one spoon (full to the
brim) per cup (fig.5).
n Remove any excess espresso ground coffee from the edge of the filter.
Important: Do not tamp the coffee down in the filter holder. The coffee is automatically tamped
using the KTS “Krups Tamping System”.
n Insert the filter holder in the device by turning it to the right as far as it will go, up to the stop (fig.7).
n Put one or two cups under the filter holder (fig.8).
As soon as the appliance reaches the required temperature, the light stops flashing.
n Turn the switch to the “ ” position (fig.8).
n When you have the desired amount of coffee, turn the switch to the " " position (fig.9).
n Unlock the filter holder: press “OPEN” while turning the filter holder to the left and remove it from the
machine (fig. 10).
n Remove the used espresso coffee grounds using the ejection system by pressing the "EJECT" button
located between the two coffee outlet nozzles (fig.11). Wash the filter holder under running water,
pressing "EJECT" to eliminate the remnants of grounds.
The filter holder now can be filled again to prepare other espressos.
5. MAKING AN ESPRESSO
KR_ESPRESSO_XP56_NAFTA_8080012562_808001256210/04/1315:16Page5
To Next Page
Loading...
