KSB DYNACTAIR 200 User Manual

Maintenance
8519.83/3 --EN
DYNACTAIR 200 to 800 -- MAINTENANCE
INSTALLATION
MAINTENANCE
1 -- General overview
2 -- Recommended tools
3 -- Installation / Safety / Exhaust ports of springs cartridges
4 -- Adjustment of adjustable end stops
5 -- Actuator disassembly
6 -- Actuator re--assembly
7 -- Actuator / Valve coupling and protection
8 -- Trouble shooting
AMRI is ISO 9001 approved

KSB DYNACTAIR 200 Specifications

General

Brand	KSB
Model	DYNACTAIR 200
Category	Controller
Language	English

Summary

General Overview

Recommended Tools

Installation and Safety

Safety Instructions

User responsibility for qualified staff, pneumatic energy disconnection, and spring hazards.

Before Any Action

Index mounting position and pointer position before performing maintenance.

Adaptation and Positioning onto the Valve

Procedures for valve adaptation, direct/adaptor fitting, and actuator mounting positions.

Exhaust Ports of Spring Cartridges

Cleaning of spring cartridge exhaust ports and protection from water.

Adjustment of Adjustable End Stops

DYNACTAIR 200 Adjustment

Procedure for adjusting closure end stops for DYNACTAIR 200 by manipulating nuts.

DYNACTAIR 400 and 800 Adjustment

Procedure for adjusting closure end stops for DYNACTAIR 400/800 by manipulating nuts.

Actuator Disassembly

Dismantling of Cover and Cylinder

Procedures for removing the actuator cover, cylinder, and associated O-rings.

Actuator Reassembly

Preparation and Kinematics Greasing

Preparing parts and greasing kinematic components before reassembly.

Cover and Cylinder Reassembly

Procedures for reassembling the actuator cover and cylinder with O-rings and retaining rings.

Actuator/Valve Coupling and Protection

Protection Against Rust

Cleaning, filling gaps, and painting interfaces to prevent rust and corrosion.

Coupling to the Valve

Procedures for direct fitting or adaptor flange fitting of the actuator to the valve.

Trouble Shooting