EasyManua.ls Logo

KSB mini-Compacta User Manual

KSB mini-Compacta
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Floodable Sewage Lifting Unit
Compacta / mini-Compacta
Replacing the Control Unit
LevelControl Basic 2 BC
Supplementary Operating
Manual
Question and Answer IconNeed help?

Do you have a question about the KSB mini-Compacta and is the answer not in the manual?

KSB mini-Compacta Specifications

General IconGeneral
BrandKSB
Modelmini-Compacta
MaterialStainless steel
Number of fan speeds3
Width598 mm
Frequency50 Hz
LightingLED

Summary

General Information and Document Structure

1.1 Principles and Target Group

Manual's purpose, scope, and intended audience of trained technical personnel.

1.3 Other Applicable Documents

References to other relevant installation and operating manuals for the pump.

1.4 Symbols Used in Manual

Explanation of symbols for instructions, safety, results, cross-references, and notes.

Safety Guidelines and Hazard Identification

2.1 Key to Safety Symbols and Markings

Defines DANGER, WARNING, and CAUTION symbols and their meanings for hazard levels.

2.2 General Safety Information

General safety information, manual comprehension, and compliance with local regulations.

2.3 Intended Use and Misuse Prevention

Specifies correct operating limits and prohibits foreseeable misuse.

Safety Procedures and Responsibilities

2.4 Personnel Qualification and Training

Requirement for qualified and trained personnel for all operational tasks.

2.5 Risks of Non-Compliance

Consequences of ignoring instructions, including warranty loss and safety hazards.

2.6 Safety Awareness and Regulations

Adherence to safety regulations, accident prevention, and hazardous substance handling.

2.7 Operator Safety Information

Protective equipment, leak containment, electrical safety, and emergency stop provisions.

Safety Information for Maintenance and Operations

2.8 Safety Information for Maintenance, Inspection and Installation Work

Safety procedures for taking equipment out of service and re-activating safety devices.

2.9 Unauthorised Modes of Operation

Prohibition of operating outside specified limits and importance of intended use for warranty.

Control Unit Replacement and Configuration

Step-by-Step Control Unit Replacement

Detailed instructions for safely replacing the LevelControl Basic 2 control unit.

Setting Unit Type Configuration

Procedure to set the unit type using navigation keys and unit type codes from a table.

Setting Inlet Nozzle Level Configuration

Procedure to configure the inlet nozzle level based on the nozzle size.

Related product manuals