How to troubleshoot no video on KT&C KPT-SPDN120HD IP Camera?
If you are experiencing no video on the screen with your KT&C IP Camera, first ensure that power is connected to all system components and that all power switches are turned ON. Also, verify the condition and connections of all cables.
What to do if KT&C KPT-SPDN120HD dome camera is not working properly?
If your KT&C IP Camera's dome camera isn't working properly, including incorrect positioning, try these steps: 1. Re-cycle the power by disconnecting and reconnecting the power cord. 2. Reset the dome camera using the Dome configuration menus by navigating to Main>System>Reboot. 3. Check the power cable connection and ensure the dome camera is properly assembled. 4. Initialize the dome camera by going to Main>System>Initialize.
General| ONVIF | Yes |
|---|---|
| Operating Humidity | Less than 90% RH |
| Ingress Protection | IP66 |
| Night Vision | Yes |
| Resolution | 1080p |
| Minimum Illumination | 0Lux (IR on) |
| WDR | Digital WDR |
| Video Compression | H.265 / H.264 / MJPEG |
| Frame Rate | Up to 30fps @ 1080p |
| Network Interface | RJ45 (10/100Base-T) |
| Protocols | TCP/IP, HTTP, HTTPS, DHCP, DNS, DDNS, RTP, RTSP, NTP, SMTP |
| Power Supply | DC12V, PoE (802.3af) |
| Operating Temperature | -30°C ~ 50°C |
To Next Page
