Need help?Do you have a question about the KTM 450 SX-F 2024 and is the answer not in the manual?
General| Displacement | 449.9 cc |
|---|---|
| Bore x Stroke | 95 mm x 63.4 mm |
| Compression Ratio | 13.1:1 |
| Starter | Electric starter |
| Transmission | 5-speed |
| Fuel System | Keihin EFI, throttle body 44 mm |
| Ignition | Keihin EMS |
| Final Drive | 520 chain |
| Cooling | Liquid cooled |
| Frame | Central Double-Cradle Type 25CrMo4 Steel |
| Front Suspension | WP XACT-USD, Ø 48 mm |
| Rear Suspension | WP XACT Monoshock with linkage |
| Front Tire | 80/100-21 |
| Fuel Tank Capacity | 7.2 liters |
| Engine Type | Single Cylinder, 4-Stroke |
| Front Brake | 260 mm |
| Rear Brake | 220 mm |
| Rear Tire | 120/90-19 |
| Seat Height | 958 mm |
| Ground Clearance | 370 mm |
| Wheelbase | 1, 485 mm ± 10 mm |
Explains symbols used in the manual for clarity.
Explains typographical formats used in the document.
Details the procedure for enabling vehicle electronics blocked for transport.
Identifies the location of the diagnostics connector and its initial use.
Provides steps for unpacking the vehicle and its initial setup procedures.
Instructions for removing cable ties, positioning the handlebar, and tightening.
Guidance on mounting and tightening the handlebar clamp screws.
Steps for positioning controls on the right and left handlebar halves.
Instructions for preassembling hand guards on the left and right sides.
Steps for mounting the left and right hand guards.
Instructions for mounting the Connectivity Unit for Factory Edition models.
Instructions for mounting the Factory-Start component.
Procedure for positioning the new footrest and pin, including spring engagement.
Details on connecting the 12-V battery terminals and charging the battery.
Instructions for applying displacement stickers and optional stickers.
Information on deactivating transport mode to start the motorcycle.
Steps to safely remove the motorcycle from a lift stand.
Procedures for lifting the motorcycle using a lift stand.
Detailed steps for removing the front wheel, including brake caliper and spindle.
Instructions for removing spacers and the brake disc guard from the front wheel.
Procedure for installing the front wheel, including wheel bearings, spacers, and spindle.
Steps for positioning and mounting the front fender.
Instructions for removing and installing the start number plate.
Procedures for removing and mounting the motorcycle seat.
Steps for installing frame protectors and engine guards for specific models.
Guidelines and precautions for charging the 12-V battery.
Procedures for disconnecting and connecting the 12-V battery negative cable.
Instructions for opening and closing the fuel tank filler cap.
Safety warnings and steps for refueling the vehicle.
Details on the approximate fuel tank capacities for different models.
Lists specific torque values for chassis components.
Details specifications and guidelines for super unleaded fuel.
Recommends specific grease for maintenance.
To Next Page