KTM 50 SX 2015 User Manual

11 MAINTENANCE WORK ON THE CHASSIS 30
601605-10
– Remove protective ring 4.
– Remove the lower triple clamp with the steering stem.
– Remove the upper steering head bearing.
11.9 Installing the lower triple clamp x
601602-10
Main work
– Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease ( p. 83)
– Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing 1.
– Check whether the top steering head seal 2 is correctly positioned.
– Slide on protective ring 3.
601603-10
– Position the upper triple clamp with the steering.
– Mount nut 4, but do not tighten it yet.
601595-11
– Position the fork legs.
Info
The upper milled groove in the fork leg must be flush with the top edge of
the upper triple clamp.
Position bleeder screws 5 to the front.
601594-12
– Tighten screws 6.
Guideline
Screw, bottom triple clamp M8 15 Nm
(11.1 lbf ft)

KTM 50 SX 2015 Specifications

General

Engine Type	Single-cylinder, 2-stroke
Displacement	49 cc
Cooling System	Liquid cooled
Transmission	Automatic
Rear Suspension	WP monoshock
Front Brake	Disc brake
Rear Brake	Disc brake
Seat Height	684 mm
Starter	Kickstarter
Front Suspension	WP upside-down Ø 35 mm
Weight	40 kg
Bore x Stroke	39.5 mm x 40 mm
Front Tire	2.50-12
Rear Tire	2.75-10