3 WORK 6
3.5 Installing the front fender
H00141-10
–
Position the fender with drill holes
in the holding lugs on the start number
plate.
The holding lugs engage in the drilled holes.
602674-11
–
Position the front fender. Mount and tighten screws
.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
3.6 Refueling
Danger
Fire hazard Fuel is highly flammable.
– Never refuel the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no
fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
– The fuel in the fuel tank expands when warm and may emerge if overfilled. Follow the instructions on refueling.
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
– Fuel must not come into contact with the skin, eyes, or clothing. Do not breathe in the fuel vapors. If contact occurs with
the eyes, rinse with water immediately and contact a physician. Immediately clean contaminated areas on the skin with
soap and water. If fuel is swallowed, contact a physician immediately. Change clothing that is contaminated with fuel.
Warning
Environmental hazard Improper handling of fuel is a danger to the environment.
– Do not allow fuel to get into the ground water, the ground, or the sewage system.
– Switch off the engine.
– Open the filler cap. ( p. 7)
400382-10
–
Fill the fuel tank with fuel up to measurement
.
Guideline
Measurement of
35 mm (1.38 in)
Fuel tank capac-
ity, approx.
3.5 l (3.7 qt.) Super unleaded (95 octane) mixed
with 2-stroke engine oil (1:60)
( p. 9)
Engine oil, 2-stroke ( p. 9)
– Close the filler cap. ( p. 7)
To Next Page
Loading...
