WORK 3
9
H01198-10
– Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
– Change front wheel bearing.
–
Clean and grease the contact surfaces
A
of the spacers.
Long-life grease ( p. 22)
– Insert the spacers.
M01698-11
–
Clean and grease the wheel spindle.
Long-life grease ( p. 22)
– Position the front wheel.
The brake linings are correctly positioned.
– Insert the wheel spindle.
M01697-10
–
Mount and tighten screw
1
.
Guideline
Screw, front
wheel spindle
M10 40 Nm (29.5 lbf ft)
Loctite
®
243™
– Operate the hand brake lever several times until the brake lin-
ings are seated correctly against the brake disc.
– Remove the motorcycle from the lift stand. ( p. 10)
– Operate the front brake and compress the fork a few times
firmly.
The fork legs straighten.
–
Tighten screws
2
.
Guideline
Screw, fork stub M6 10 Nm (7.4 lbf ft)
3.7 Raising the motorcycle with a lift stand
Note
Danger of damage The parked vehicle can roll away or fall over.
– Park the vehicle on a firm and level surface.
401942-01
– Raise the motorcycle at the frame underneath the engine.
Lift stand (78929955100)
Neither wheel is in contact with the ground.
– Secure the motorcycle against falling over.
To Next Page
Loading...
