Kubota AP-SR2790 - User Manual

Questions and Answers

B
Brandon TurnerAug 15, 2025
What to do if Kubota AP-SR2790 Farm Equipment roller will not turn?
- K
  Katherine ArnoldAug 15, 2025
  Several issues can cause the roller to not turn. It might be due to the hydraulic valve on the skid steer loader not being engaged, a worn, damaged, insufficient, or inadequate hydraulic pump, insufficient oil in the system, a worn or damaged housing, air in the hydraulic hoses, a broken hose, loose or damaged hoses, an obstruction between the roller and material control blade, the drive chain being off, or loose or damaged connections. Please, check all these potential causes.
F
Francis PhillipsAug 18, 2025
What to do if Kubota Farm Equipment has too much dirt going into the windrow?
- W
  Wendy MyersAug 18, 2025
  If too much dirt is going into the windrow or over the material control blade, try reducing the ground speed, raising the material control blade, or lowering the gauge wheels.
D
Dakota ClarkAug 21, 2025
How to fix roller gouging on the end on Kubota AP-SR2790?
- D
  Debra AbbottAug 21, 2025
  To fix roller gouging, ensure the gauge wheel on the chaincase side is approximately 1" lower than the non-drive side gauge wheel for consistent leveling. Also, set the gauge wheel depth and correct the air pressure in the gauge wheels.
C
Cassidy ZavalaAug 25, 2025
What to do if Kubota AP-SR2790 operating depth insufficient?
- R
  riverawalterAug 25, 2025
  If the operating depth is insufficient, try raising the gauge wheels, increasing the skid steer rpm, or cleaning the roller.
R
Robert EstradaAug 28, 2025
Why Kubota Farm Equipment roller balling up with soil?
- N
  Nathan MitchellAug 28, 2025
  If the roller is balling up with soil, wait until the soil dries.
J
Joseph SuttonAug 31, 2025
What to do if Kubota Farm Equipment has too many rocks passing between material control blade and the roller?
- T
  Thomas BrownAug 31, 2025
  If too many rocks are passing between the material control blade and the roller, lower the material control blade.
S
singhwillieSep 4, 2025
How to resolve Powered Rake bumping on ground for Kubota AP-SR2790 Farm Equipment?
- T
  Timothy BallSep 4, 2025
  To resolve the powered rake bumping on the ground, clean the roller. Also, increase the roller speed if it's turning slowly, or decrease the roller speed if it's turning fast.
S
Sierra MeltonSep 7, 2025
Why Kubota Farm Equipment machine makes intermittent clicking noise?
- J
  Justin GillSep 7, 2025
  An intermittent clicking noise could mean a damaged sprocket, so check and replace if needed. It could also indicate a worn drive chain, which should also be checked and replaced if necessary.
R
Rachel HaysSep 10, 2025
What to do if Kubota AP-SR2790 Farm Equipment roller angling opposite of switch?
- J
  Jennifer MartinSep 10, 2025
  If the roller is angling opposite of the switch, move the wire on the top solenoid to the bottom solenoid and the wire on the bottom solenoid to the top solenoid.