56
ENGLISH
쏋 Cutting Height Control Dial
Raise the mower deck to the top position by pulling
the hydraulic lift lever backward (see Hydraulic lift
lever page 48). Turn the cutting height control dial to
the desired cutting height.
Lower the mower deck by pushing the hydraulic lift
lever forward.
Then the mower deck will be set to the cutting height.
(1) Cutting height control dial
쏋 Hour Meter
The hour meter starts to run when the key switch is
turned to the “ON” position.
(1) Hour meter
쏋 Easy Checker
TM
(A) If this warning light comes on during operation,
check the electrical charging system or consult
your KUBOTA Dealer.
(B) If this warning light comes on during operation,
check level of engine oil.
(C) If the fuel in the tank goes below the prescribed
level, the warning lamp in the Easy Checker™ will
come on.
If this should happen during operation, refuel as
soon as possible.
(D) If this warning light comes on during operation,
take the actions according to “Engine
Overheating Precautions” .
(E) Glow plug Indicator (Pre-heating Indicator)
When the key switch is in the “Preheat” position,
the glow plug indicator illuminates. If the engine
is preheated completely, the glow plug indicator
turns off automatically.
To Next Page
Loading...
