3) Parameter display when pressing key .
4) When you change parameter ,press key, then white input window
will display in bottom line.
when input window display,press a number and key,
it will go to desired parameter
Ex)When parameter 43'setting value want
change to 0.152221
After confirming cursor is located in [No.],
→ → →
→ →
→ enter the above order.
☞ After parameter change is finished, press key,
operation screen will display.
2/5
parameter
number
parameter setting value
& unit
explanation for
parameter & setting
Blue shaded area is cursor..
Press key to move down ,change the
setting value.
If press key while the cursor is located,
input
window display and you can input a value..
To Next Page
Loading...