To Next PageTo Next PageHow to deal with fuel mixed into lubricant oil in Kubota Front End Loaders?
If you find fuel mixed into the lubricant oil of your Kubota Front End Loader, it could be due to a worn injection pump plunger (repair or replace), deficient nozzle injection (repair or replace nozzle), or a broken injection pump (replace).
Why is the belt slipping on my Kubota Lawn Mower?
If the belt is slipping on your Kubota Lawn Mower, it could be due to a plugged mower deck, debris in the pulleys, or a worn belt. Unplug and clean the mower deck, clean the pulleys, or replace the belt.
How to stop excessive vibration in my Kubota Lawn Mower?
Excessive vibration in your Kubota Lawn Mower can be caused by debris on the mower deck or in the pulleys, a damaged drive belt or pulleys, pulleys that are out of alignment, or blades that are out of balance. Clean the mower deck and pulleys. Replace the drive belt and pulleys if damaged. Have the blades balanced, and consult your KUBOTA dealer.
How to troubleshoot a Kubota Front End Loaders engine that does not start?
If your Kubota Front End Loader engine doesn't start, several factors could be at play. Ensure you have sufficient fuel by filling the tank. If fuel is present, there might be air in the fuel system, requiring you to bleed it. Other potential issues include water in the fuel system (change the fuel), a clogged fuel line (clean it), or a clogged fuel filter (change it). Using the specified fuel is also important.
Why is my Kubota Front End Loaders producing black exhaust?
If you notice black or dark gray exhaust gas from your Kubota Front End Loader, it could be due to several reasons. First, check if the loader is overloaded and reduce the load if necessary. Ensure you're using the specified fuel grade. A clogged fuel filter or air cleaner could also be the culprit, so replace or clean them, respectively. Finally, a deficient nozzle injection may require you to repair or replace the nozzle.
Why is my Kubota Front End Loaders blowing blue or white smoke?
If your Kubota Front End Loader is producing either white or blue exhaust gas, it could be due to several reasons. It may be caused by excessive engine oil, so reduce it to the specified level. Also, worn or stuck piston rings and cylinders, which require repair or replacement, or incorrect injection timing (adjust it) can cause this issue. Another potential reason is deficient compression, which needs to be checked.
What causes high oil pressure in Kubota Front End Loaders?
If your Kubota Front End Loader shows high oil pressure, ensure you are using the specified type of oil. A damaged relief valve could also be the cause, requiring replacement.
What causes low oil pressure in Kubota Front End Loaders?
If you notice low oil pressure in your Kubota Front End Loader, there are several potential causes. First, check if the engine oil level is insufficient and fill if needed. Inspect the oil strainer and oil filter for clogs and clean or replace them, respectively. The relief valve might be stuck with dirt (clean it) or have a weakened or broken spring (replace). Excessive oil clearance in the crankshaft, crankpin bearing or rocker arm necessitate replacement. Also, check for clogged oil passages (clean) and ensure you are using the specified type of oil. Finally, the oil pump itself might be damaged, requiring repair or replacement.
Why does Kubota Front End Loaders battery drain so fast?
If your Kubota Front End Loader's battery is quickly discharging, several factors could be contributing. Start by checking if the battery electrolyte level is insufficient; fill with distilled water and charge. Inspect the fan belt for slippage and adjust the tension or replace it if necessary. Also, check for disconnected wiring and reconnect. A damaged rectifier or alternator could also be the cause, requiring replacement, as well as a damaged battery which should be replaced.
What to do if Kubota Front End Loaders starter does not run?
If the starter on your Kubota Front End Loader doesn't run, several things could be wrong. The battery might be discharged, so charge it. The starter itself could be malfunctioning, requiring repair or replacement. Other potential issues include a malfunctioning main switch or safety switches (repair, adjust, or replace as needed), or disconnected wiring (connect).
General
