AFTER SALES SUPPORT
1300 777 137
10
service@unclebills.com.au
MODEL: IA0397 PRODUCT CODE: 49648 06/2015
Instructions
Timer
The timer can be set for up to 30 minutes. The elements will only begin to heat once the
timer has been set, and the lid shut. Once the timer has nished counting down, heating will
automatically stop and the bell will ring to indicate the timer has elapsed.
Temperature Control Dial
Set your desired heating temperature, from 0 up to 250°C.
Heating Elements
Dual – Operates both the lower and upper heating elements.
Lower – Operates the lower heating element for cooking the base of the pizza.
Upper – Operates the upper heating element for cooking the toppings of the pizza.
OFF – Turns heating elements o.
Cooking on the Pizza Stone
1. Plug the power cord into a power outlet and switch on.
2. The control dials should all be set at the OFF position – lift the lid and ensure the pizza stone
is sitting correctly on the rotary base, and there is nothing else in the Pizza Oven.
3. Pre-heat the Pizza Oven by turning the temperature control dial to 150 °C and then set your
timer to at least 5 minutes. When cooking with the pizza stone, make sure dual heating
element mode is selected.
TIP: Pre-heating your oven before use will ensure better results.
4. If you are cooking fresh dough pizza, lightly coat the surface of the stone with some plain
our before placing the pizza directly onto the surface of the pizza stone.
CAUTION: If making your own pizza, it is recommended to make it on a separate board and
then transfer it to the pizza stone once you are ready to cook. Be careful not to over-ll or
mount your toppings too high – the toppings should always be below the height of the top
heating element to avoid burning them.
WARNING: The pizza stone will be hot after the pre-heat. DO NOT TOUCH IT AT ANYTIME
DURING THE COOKING PROCESS.
To Next Page
Loading...
