General Safety Instructions (Cont.)
Electrical safety
• Check if the voltage indicated on the base of the appliance corresponds to
the local mains voltage before you connect the appliance.
• Do not use the appliance when the mains cord, the plug or other components
are damaged.
• If the mains cord is damaged, it must be replaced by an authorised service
centre or by similarly qualified persons in order to avoid a hazard. Contact our
after sales support line for advice.
• To avoid a circuit overload when using this product, do not operate another
high-wattage product on the same electrical circuit.
• Avoid the use of an extension cord because the extension cord may overheat
increasing the risk of fire. However, if an extension cord must be used, it must
be rated not less than 1875W.
CAUTION! Important product-specific instructions
• Make sure all parts are correctly assembled before you switch on the
appliance.
• Only use the appliance when safety clamps are locked.
• Do not operate the appliance for more than 40 seconds at a time when juicing
heavy loads and let it cool down sufficiently afterwards.
• Never reach into the feeding chute with your fingers or an object while the
appliance is running. Only use the pusher for this purpose.
• Only unlock the clamps after you have switched the appliance off and the filter
has stopped rotating.
• Do not remove the pulp container when the appliance is in operation.
• Do not touch the small cutting blades in the base of the filter.
• Always unplug the appliance after use.
• Never immerse the motor unit in water or any other liquid. Do not rinse it
either.
• Do not use the appliance if the rotating sieve is damaged.
To Next Page
Loading...
