Getting Started
Before first use
• Unpack the appliance but keep all packaging materials until you have made
sure your new juice extractor is undamaged and in good working order.
Plastic wrapping can be a suffocation hazard for babies and young children,
so ensure all packaging materials are out of their reach.
• Fully unwind the cord and inspect it for damage. Do not use the appliance if
anything has been damaged. In such a case, contact our after sales support
line for advice on examination, repair or return of the damaged product.
• Read this manual to familiarise yourself with all the parts. Pay particular
attention to the safety instructions on the previous pages.
• Make sure the appliance is disconnected from the power supply.
• Holding the rim of the filter with you fingers, lift the stainless steel filter out of
the juice collector. Then lift the plastic juice collector off the motor unit.
• Wash all detachable parts with a soft cloth or sponge in warm water and a
little washing-up detergent to remove any dust or other remnants from the
manufacturing process. CAUTION! Take care to avoid injury from the sharp
blades at the bottom of the filter.
• Rinse the parts with clean water and dry.
• When all parts are thoroughly dry, assemble the unit as follows.
Assembly
• Place the juice collector onto the top of the motor base — see Fig. 1 below.
• Tilt the motor unit slightly to attach the pulp container to the appliance, fitting
the top end underneath the pulp spout first, then lining up the bottom end —
see Fig. 2 below.
1
2
To Next Page
Loading...
