Operation
2. Hold the rear of the top cowling and slightly tilt
the outboard motor up until the tilt support bar
automatically locks. The outboard motor can be
operated in this position for shallow water cruising.
The outboard motor is equipped with 3 shallow water
cruising positions.
Tilt support bar
Procedure for returning to normal cruising
1. To tilt the outboard motor down to the
normal running position, move the gear shift lever to
the neutral position.
Cruising in other conditions
Cruising in salt water
After operating in salt water, flush the cooling water
passages with fresh water to prevent
them from
becoming clogged. Also rinse the outside of the
outboard motor with fresh water.
Cruising in muddy, turbid, or acidic water Water
in some areas can be acidic or with a lot of
sediment in it, such as muddy or turbid (cloudy)
water. After operating in such water,
flush the
cooling passages with fresh water to prevent
corrosion. Also rinse the outside of
the outboard
motor with fresh water.
1.
Neutral position
2. Slightly tilt the outboard motor up, and then
slowly tilt the outboard motor down while pulling the tilt
support bar up.
43
To Next Page
Loading...