Maintenance
1.
Fuel filter
Inspecting idle speed
NOTICE
When checking the engine idle speed,
make
sure to supply water to the cooling
water
passages by placing the outboard
motor in the
water or by using a flushing
attachment or test
tank.
To check the engine idle speed, a diagnostic
tachometer is required.
Changing engine oil
NOTICE
Change the engine oil after the first 20
hours
of operation or 3 months, and every
100 hours
or at 1-year intervals thereafter.
Otherwise the
engine will wear quickly.
Extract the engine oil with an oil changer.
1.
Put the outboard motor in an upright
position (not tilted). NOTICE: If the motor
is not
level, the oil level indicated on
the dipstick
may not be accurate.
2.
Start the engine. Warm it up and keep
the
idle speed for 5-10 minutes.
3.
Stop the engine and leave it for 5-10
minutes.
4.
Remove the top cowling.
5.
Remove the oil filler cap.
1.
Oil filler cap
2.
Oil lubrication check window
TIP:
The oil lubrication check window does not
indicate the engine oil level. Use the oil
lubrication check window to make sure that
the
engine is being lubricated with oil while
it is
running.
6.
Insert the tube of the oil changer into
the
oil filler hole, and then extract the engine
oil completely using the oil changer.
To Next Page
Loading...