Maintenance
1.
Oil changer
7.
If the oil changer is not available, remove
the drain screw while holding a container
under
the drain hole. Let the oil drain
completely. Wipe
up any spilled oil immediately.
10.
Install the oil filler cap and tighten it
completely.
11.
Leave the outboard motor for 5-10
minutes.
12.
Remove the oil filler cap and wipe the
attached oil dipstick clean.
13.
Install the oil filler cap and tighten it
completely.
14.
Remove the oil filler cap again and
check
that the oil level on the dipstick is
between the upper and lower marks. If the
oil level is not at the proper level, add or
extract oil until the oil is between the
upper and lower marks.
15A. Start the engine and make sure that
there
are no oil leaks. NOTICE: If there are
oil
leaks, stop the engine and find the
cause.
1.
Drain screw
2.
Washer
8. If the drain screw was removed, install a
new
washer and drain screw, and then
tighten the drain
screen.
Engine oil drain bolt:
18.0 Nm (1.84 kgf-m, 13.3 ft-lb)
9. Add the correct amount of oil through the
filler
hole. NOTICE: Overfilling the oil
tank could
cause leakage or damage.
If the oil level is
above the upper mark,
extract oil until the oil
is between the
upper and lower marks.
.
56
To Next Page
Loading...