Checking the Function of the Scooter
01: Driving Light Switch
02: Turning Light Switch
03: Horn Switch
04: Rear Brake Controler Bar
05: Accelerator
06: Meter Power Button
07: Model Button
08: Front Brake Controler Bar
09: Volt Display
10: Power Lock
11: Power Lock Key
Control before Operating
1. Checking the start of the accelerator and steering wheel. Turning the power off,
pull the throttle lever a few times. Make sure it returns to its original position.
Please do not pull the trigger, work smoothly.
2. Checking brakes and cables. Check the braking power. If the braking system is
weak, please adjust before use. If the brake is jammed or there is an unusual noise,
check the inner brake cable of wear and deformation.
3. Check tire pressure and condition. Check the front and rear tires whether there is
puncture and tread wear. Make sure the tire pressure is at the recommended level:
23 kg per SQCM. Replace tires by wear degree (damage, tread wear, etc.).
4. Checking the folding part and the steering wheel. Folding/Unfolding: make sure
the folding lock lever is locked and in the upright position. Make sure the stand is
folding smoothly.
5. General condition check: Some parts of the electric scooter require regular
maintenance check: chassis fork, tires, bearing, cable, other parts.
To Next Page
Loading...
