KUHN GF502 - Page 5

2. - Contents
GF502
5
KN245BGB_B
Gyrotedder
4.4 Road safety equipment and recommendations............................................................................. 29
4.4.1 Tyre pressure ................................................................................................................... 30
4.4.2 Instructions specific to France.......................................................................................... 30
4.4.3 Instructions specific to Italy .............................................................................................. 30
4.5 Likely critical failures...................................................................................................................... 30
4.6 Incorrect use of the machine by the user ...................................................................................... 31
4.7 Limit state criteria........................................................................................................................... 31
5. Machine specifications................................................................................................ 32
5.1 Description and glossary ............................................................................................................... 32
5.1.1 Designated use of the machine........................................................................................ 32
5.2 Technical specifications................................................................................................................. 33
5.2.1 Designated parameters.................................................................................................... 33
5.3 Required equipment ...................................................................................................................... 34
5.3.1 Primary PTO shaft............................................................................................................ 34
5.3.2 Lighting and signalling...................................................................................................... 34
5.4 Sound levels.................................................................................................................................. 35
6. Putting into service...................................................................................................... 36
6.1 Description of control elements ..................................................................................................... 36
6.2 Coupling and uncoupling............................................................................................................... 37
6.2.1 Preparing the tractor......................................................................................................... 37
6.2.2 Coupling the machine.......................................................................................................39
6.2.3 Hydraulic connection........................................................................................................ 40
6.2.4 Primary PTO shaft............................................................................................................ 41
6.2.5 Uncoupling the machine................................................................................................... 43
7. Instructions for transport............................................................................................ 45
7.1 Putting the machine into transport position ................................................................................... 45
7.2 Conformity with the road regulations............................................................................................. 47
7.3 Machine transport using transport means ..................................................................................... 47
8. Instructions for work ................................................................................................... 48
8.1 Putting the machine into work position.......................................................................................... 48
8.2 Putting the machine in headland turn position............................................................................... 49
8.3 Adjustments in working position .................................................................................................... 50
8.3.1 Pitch angle adjustment.....................................................................................................50
8.3.2 Work in oblique position ...................................................................................................50
8.3.3 Adjustment of the travel range for work on slopes ........................................................... 51
8.4 Machine use .................................................................................................................................. 52
8.4.1 Groundspeed and PTO speed ......................................................................................... 52