Kukirin G2 Pro - Assembly Guidelines; Tips for Beginners

Unpacking and assembly
Fold and unfold
1.Fasten the folder, place the
handle tube onto the retaining
bracket and tighten the screws.
2.Fasten the pedestal with
screws, place the saddle into the
bracket and adjust the height.
3.Lock the saddle latch and
check the bike.
1.Release the hook and lift the
standing bar until the folder
automatically locks the first lock.
2.Fasten the folder, lift the saddle
bracket and pull and fasten quick
saddle removal device.
3.Adjust the saddle height and
lock the saddle latch.
6.Assembly guidelines
05
06
EN EN
8.Operation instruction
7.Tips for Beginners
Wear protective devices, including qualified helmet, knee pads, wrist pads, and elbow pads.
Practice riding until you can easily get on, move forward, make a turn, stop and get off the electric bike.
Avoid run over anything that may cling onto or get stuck in wheels.
A wide road is preferred; do not ride the electric bike on a slope, pedestrian or a road with obstacle on until
you are proficient in riding the bike.
Non-zero start
Single drive
Voltage
Battery level
Headlight sign
Left turn
Speed
Brake sign
Right turn
Gear position
Speed unit
Mileage/Fault code
Cruise sign
1.Long press the power button to turn it on/off.
2.Short press the power button once to switch gears. There are three levels.
3.Press the power button three times in a row to enter the menu setting interface. The instrument panel will display
P01, P02, P03, P04, P05, P06, P08, PA, PB.
P01: Kilometer/mile selection settings, (default is kilometers).
P02: Voltage level setting, 36V/48V/52V/60V/72V (default value is 48V).
P03: The unit of wheel diameter is inch, which can be set to 080-160 (default is 100).
P04: Speed measurement magnetic pole range: 1-100, (default is 30).
P05: Cruise selection, 0 is no cruise, 1 is cruise, (default is no cruise).
P06: Zero start/non zero start settings, 0 is zero start, 1 is non zero start, (default is zero start).
P08: For the setting of sleep time, 0 is not sleep, and other numbers are sleep time, (default is 5 minutes).
PA: Starting force setting, 1-5, 1 minimum, 5 maximum.
PB: For the braking force setting, it is from 0-5, 0 is turned off, and the braking force of 1-5 gradually increases.
Left brake lever
Instrument panel
Right brake lever
Handlebar grip
Throttle thumb shifter
Ignition lock
Handlebar grip
Headlight switch
Horn
Power switch