7
• Then dry the surface carefully by applying a stream of compressed air until the fluid film has disap-
peared and the surface is no longer shiny. Then rinse thoroughly with water.
• Deep cavities and/or areas near the pulp should be covered with a suitable cavity lining before the
desensitizer is applied.
If a single application of GLUMA Desensitizer does not produce sufficient and sustained pain relief,
the treatment can be repeated at the same or a subsequent appointment before alternative treatments
are used.
Treatment of dentine prepared to receive complete cast restorations
• Protect mucous membranes by using a rubber dam.
• Remove moisture from the prepared dentine by applying a gentle stream of compressed air.
• Apply GLUMA Desensitizer with a pellet and leave for 30–60 seconds. Make sure that only the
smallest possible amount required is applied and that it only comes into contact with the area to
be treated.
• Dry the dentinal surface carefully by applying a stream of compressed air, rinse off thoroughly with
water and apply suction.
• Cover cavities and/or areas near the pulp with suitable cavity linings before applying the desensi-
tizer.
Further precautions
GLUMA Desensitizer should only be used by a dentist.
GLUMA Desensitizer should not be used after the expiry date (see warning on label).
Do not store at temperatures of more than 25°C (77°F). Keep out of the reach of children.
1606_8017_GBA_Gluma_Desensitizer_NENA.indd 71606_8017_GBA_Gluma_Desensitizer_NENA.indd 7 17.06.16 12:2717.06.16 12:27
To Next Page
Loading...
