FNL Getting Started
4 / 22
2 Install
2.1 Install FNL
Install FNL according to the Installation Instructions (document
FNL_EN.pdf), by connecting FNL to a power supply (24 Volts DC) as
well as to an Ethernet network. The A PC used for the FNL
configuration must be connected to the same Ethernet network as
well. A direct connection between the PC and FNL via an Ethernet
cross cable is also possible.
2.2 Install Software
The delivered software on the CD needs to be installed on a
Windows-based PC. Start the setup program and follow the
instructions to install the software. The setup program copies all
necessary components to the PC.
Install
To Next Page
Loading...
Need help?
General