Need help?Do you have a question about the Kurt D688 AngLock Vise Base Assembly and is the answer not in the manual?
Explains O-Ring installation for specific clamping needs.
Details the installation and function of the chip guard.
Outlines daily and weekly tasks for vise maintenance.
Details monthly procedures for cleaning and re-assembly.
Describes maintenance tasks to be performed every 3 to 6 months.
General| Type | Vise Base Assembly |
|---|---|
| Base Type | AngLock |
| Material | Ductile Iron |
| Style | Stationary |
| For Use With | Milling Machines |
| Jaw Width | 6 inches |
| Jaw Opening | 8 inches |
| Compatibility | D688 Vises |
To Next Page
