PAGE
2
STEP 4
There are three mounting holes with splines around them in the Mini Board. You may use these to
locate the Board forward or rearward, tilt up or down, from the stock peg (center) location. To
adjust the Mini Board, remove the 5/16”-18 socket head cap screw and washer from the Mini
Board. This will leave the adapter on the motorcycle. Choose your location and orientation of
the Mini Board. Insert the 5/16”-18 socket head cap screw, with flat washer, through the Mini
Board and thread it into the mount making sure the splines on the Mini Board are engaged in the
splines on the mount in the desired location. Tighten securely.
ENSURE THAT THE INSTALLATION OF THESE MINI BOARDS DOES NOT
INTERFERE WITH THE PROPER OPERATION OF THE MOTORCYCLE BEFORE
RIDING. INTERFERENCE WITH THE CONTROLS OR ANY COMPONENT ON
THE MOTORCYCLE MAY CAUSE LOSS OF CONTROL RESULTING IN
SERIOUS INJURY OR DEATH.
It is the installer’s responsibility to ensure that all of the fasteners (including
pre-assembled) are tightened before operation of the motorcycle. Küryakyn will
not warranty components lost due to improper installation. Periodic maintenance
may be required.
Ride On!
PREMIUM MINI BOARDS INSTALLATION
To Previous Page
Loading...
