Kurzweil K2000 - Troubleshooting Common Problems (Part 3); LCD Readability and Disk Errors

SECTION 4
rROUBLES.DOC 12/22/92
4.9 OTHER POSSIBLE PROBLEMS
CONDITION POSSIBLE CAOSE
No sound at MIX outputs or
headphones.
Left MIX output seems louder
than Right MIX output when
used individually.
Volume slider has no effect.
Programs, Setups, Songs, etc.
are missing.
9
1.
1.
1.
Audio cables are plugged
into the "A" or "B"
outputs. Cables plugged
into some or all of the
separate outputs remove
the audio signal from the
MIX and headphone
outputs. See Chapter 18
- "Audio Outputs" of the
Musician's Guide for
detailed configurations.
This is normal. When a
cable is plugged into the
left MIX output alone,
both the left AND the
right audio signals are
routed to the jack. When
a
cable is plugged into
right MIX output alone,
only the right channel
audio signal is heard.
Separate outputs are in
use - the volume slider
does not affect the "A"
or "B" outputs.
2. MIDI volume has been
assigned to a different
controller.
1.
Batteries have run down
or have been disconnec-
ted. If the batteries
have failed, the message
"Battery voltage is low -
0.0 volts" will appear in
the display on power-up.
All user data will be
permanently lost if this
occurs. REFER TO SECTION
FOR DETAILS ON
BATTERY REPLACEMENT.