Kurzweil K2000R - Section 2; Verify SIMMs Functionality

SECTION 2
back. of unIt
order 01 Installation - 4 SIMMs ----
2S1MMs ~
1 2
1
3 "
2
I Figure 2.12 - SIMM Installation I
1C2RVOLTS.DOC 01/05/93
• Insert a SIMM into the proper socket at a 60° angle (Figure 2.12).
• Press the SIMM firmly into the socket until it clicks into place.
• Pull the latches on each end of the socket outward, rotate the SIMM to a
vertical position, and release the latches.
• Repeat the above three steps to install remaining SIMMs.
• Once all SIMMs have been inserted, inspect for proper installation - make
certain the top edges of all like SIMMs are at the same height and parallel
to the printed circuit board.
• Close the unit as describe in Section 3 of the Service Manual.
2.22.2
To verify the SIMMs are functional:
• Plug in the power supply line cord, and turn the unit on.
• Once the unit has initialized, press the "DISK" button.
• Confirm the "Samples:####K" figure displayed in the center of the status
bar corresponds to the total amount of sample RAM installed in the unit.
24