Live Mode Programs
910309
3
Live Mode Programs
Live Mode also includes two Live Mode Keymaps at 197 and 198 (Left and Right respectively).
Usage Notes
To use the programs, you must hold down a key (C4, unless you’re going for a special effect) for the inputs to
run through V.A.S.T. An alternative way to trigger the sound is to edit the Control Setup found in the MIDI
XMIT page. For example, using Panel Switch 2 (PSw 2), changing the switch type to Note Toggle, and using
C4 as the destination. This allows you to turn the program on/off via a button press and also keeps sound
sustaining while the button is on. This obviously only works for owners of the keyboards, not racks, but the
idea transfers to any MIDI controller. Keep in mind, that if you change the live mode program, you need to
restrike a key (or Button) for the signal to go through that program.
You can also edit the live mode keymap to ignore release if you only want to use the keyboard to activate Live
Mode.
You cannot sample and use live mode together, the two functions use the same components.
Prg. # Program Name Controller Assignments
750 LM Notched Pan PWheel>Reverse FX, Data>Pan LFO Rate, B> Notch Freq, C>Width
751 LM Talking MW Data>Dist, MW>Filter Freq, B> Tremolo Rate
752 LM Synth Sliders PWheel>Reverse FX, MW>LFO Depth, Data>Attk Rate, B>Release
Rate, C> LFO Rate, D+Keytracking>Filter Freq., E> Resonance,
F>Flange Level, G>Delay Feedback, H>Flange Delay Wet/Dry
753 LM Hi Resonance Data> Filter Freq., B>LFO Rate, C>Resonance
754 LM Amp Mod Osc Data>Amp Mod Depth, B>Osc Pitch, C>Wrap LFO Rate,
MW>Reverse FX, G>Flange Level
755 LM Notch/Shaper Data> Filter, Shaper, MW>LFO Rate
756 LM Twin Peaks Data, MW>Filter Freq., B>Width, C>Separation
757 LM Air Filter Data> Filter Freq., MW>Resonance, B>Separation LFO Rate
758 LM Parametric Data> Filter Freq., MW>EQ Peak Width, B>Para EQ Amp
759 LiveMode Default Stereo Default, Slider H controls the Digitech Effect Wet/Dry Mix
To Next Page
Loading...
