Kurzweil K2500 - Page 8

Front Panel
Front Panel Quick Reference
1-2
When in this mode—Pressing the Edit button…
Program mode— …enters the Program Editor, where you can edit the currently se-
lected program. Chapter 6 in the Performance Guide covers the Pro-
gram Editor.
Setup mode— …enters the Setup Editor, where you can edit the currently selected
setup. Chapter 7 in the Performance Guide describes the Setup Editor.
Quick Access mode— …enters the Quick Access Editor, where you can change the pro-
gram or setup assigned to the bank slot that was selected when you
entered the Quick Access Editor. See Chapter 8 in the Performance
Guide .
Effects mode— …enters the Effects Editor, where you can edit the currently selected
effects preset. Chapter 9 in the Performance Guide explains the Effects
Editor.
MIDI mode— …enters the Velocity Map or Pressure Map Editor if the Velocity or
Pressure Map parameter is selected on either the XMIT page or the
RECV page. See Chapter 17 in the Performance Guide . Enters the Pro-
gram Editor if the Program parameter is selected on the CHANLS
page. See Chapter 6 in the Performance Guide .
Master mode— …enters the Velocity Map, Pressure Map, or Intonation Table Editor
if the VelTouch, PressTouch, or Intonation parameter is selected.
Song mode— …enters the Song Editor. The Song Editor is discussed in Chapter 12
in the Performance Guide . Enters the Program Editor if the Program
parameter is highlighted when Edit is pressed.
Disk mode— …has no effect.
Soft Buttons
Functions change depending on current display page. Function of each button is displayed on
bottom line of display.
EXIT Button
Press to leave various editors. If you’ve made any changes while in the editor, you will be
prompted to save them.
Cursor Buttons
Press the corresponding button to move the cursor up, down, left, or right in the display.
Different parameter values will be highlighted as buttons are pressed.
Alpha Wheel
For data entry. Rotate clockwise to increase value of currently selected parameter,
counterclockwise to decrease.
Plus / Minus Buttons (- and +)
Under the Alpha Wheel. Press to increase or decrease the value of the currently selected
parameter by the smallest possible amount.