A-4
K2600 Boot Loader
Run Diags
Dagnistics page, where you can choose from a series of diagnostic tests. These tests can be useful
in identifying problems you might be having with your instrument.
------|K2600
|Diagnostic||Ver|0.02|______
LCD|||||||||
|||Scanner|||||Sine|Wave||||
Engine|Blk|||||MIDI|Uart|||Sound|ROM||||
Object|Blk|||||FDD|R/W|||||Sound|RAM||||
RAM/PRAM|||||||SCSI||||||||1st|NVRAM||||
I/O|Port|||||||VLSI|&|ZRAM|2nd|NVRAM||||
FDD|In
i
t||||||
|SamplingOpt|KDFX|Rel
ays|
|
BurnIn
|
Forever
|||||||||||||||||||||
|OK|
|
A Few Precautions
1. Turn down your sound system before beginning diagnostics!
2. Before executing the MIDI UART diagnostic, connect a MIDI cable from the K2600Õs MIDI
Out port to its MIDI In port. If you do not do this, the MIDI UART test will fail.
Running the Tests
Select the desired test with the Alpha Wheel or cursor buttons, then press OK to begin the test.
When youÕre Þnished, restart your K2600 to return to regular operation.
To Previous Page
Loading...
Need help?
General
