6-28
Program Mode and the Program Editor
The F4 AMP Page
The F4 AMP Page
Press the F4 AMP soft button to call up this page, which features Þve of the six common DSP
control parameters, in this case controlling the Þnal amplitude of the current layer before it
reaches the audio outputs. ThereÕs also a parameter that enables you to pad (attenuate) the
current layerÕs signal before its Þnal ampliÞcation.
EditProg:F4|AMP(FINAL|AMP)|<>Layer:1/1||
Adjust:6dB||||||||||Src1||:OFF||||||||||
||||||||||||||||||||Depth|:0dB||||||||||
||||||||||||||||||||Src2||:OFF||||||||||
KeyTrk:|0.00dB/key||DptCtl:MWheel|||||||
VelTrk:20dB|||||||||MinDpt:0dB||||||||||
Pad|||:0dB||||||||||MaxDpt:0dB||||||||||
<more||F1|||||F2|||||F3|||||F4|AMP|more>
Adjust
Adjust the overall amplitude (gain) of the currently selected layer. In multi-layer programs, this
parameter adjusts the amplitude of the layers relative to each other. This is the Þnal output
control for the layer (post-amp pad). Be careful not to set this too high! If one of your layers is
too loud, itÕs generally better to cut its level than to boost the others. This will keep distortion to
a minimum.
Key Tracking
This uses the MIDI note numbers of the notes you play as a control source affecting the
individual amplitudes of each note in the current layer. Positive values increase the amplitude
as you play higher-pitched notes. For example, if the key tracking is .20 dB/key, then C
#
4 will be
.20 dB louder than C 4 if triggered with the same attack velocity. If the value for this parameter
were negative, C
#
4 would have less amplitude than C 4. A word of caution here: values above
0.30 dB/key (or below Ð0.30) can generate extremely high amplitude levels. If you set this
parameter that high without lowering the value of the Adjust parameter to -12 dB or lower, your
sound may clip, which can be useful, but it isnÕt necessarily what you want.
Parameter Range of Values Default
Adjust –96 to 48 Db 6
Key Tracking ± 2 Db per key 0
Velocity Tracking ± 96 Db 20
Pad 0, 6, 12, 18 Db 0
Source 1 Control Source List Off
Depth ± 96 Db 0
Source 2 Control Source List Off
Depth Control Control Source List Mwheel
Minimum Depth ± 96 Db 0
Maximum Depth ± 96 Db 0
To Next Page
Loading...