11-2
Glossary
Dialog
A page that prompts you to enter information that the K2600 needs in order to execute
an operation. Dialogs appear, for example, when you initiate a Save or Delete
operation.
Digital
A term used widely in electronics-related Þelds to describe a method of representing
information as a series of binary digits (bits)Ñ1s and 0s. Digital computers process
these strings of 1s and 0s by converting them into an electrical signal that is always in
one of two very deÞnite states: ÒonÓ or Òoff.Ó This is much more precise than the
analog method, therefore digital computers can operate at speeds unattainable by
analog devices. Digital synthesizers like the K2600 are actually computers that process
vast strings of digital information signals, eventually converting them (at the audio
output) into the analog signals that ßow into PAs and other audio systems. See also
Analog.
Digital Signal Processing
The term ÒSignal processingÓ refers to a vast range of functions, all of which have in
common the fact that they act upon an electric current as it ßows through a circuit or
group of circuits. A simple form of signal processing is the distortion box used by
many guitarists.
Digital
signal processing refers to similar processes that are
performed by digital (see) circuitry as opposed to analog (see) circuitry. Many of the
effects devices available today use digital signal processing techniques.
Drum Program
Any program consisting of more than three layers. So called because in the K2000, a
special channel was required to handle programs with more than three layersÑwhich
typically were-multi-timbral percussion programs.
Editor
The complete set of parameters used to modify a particular aspect of the K2600, for
example, the currently selected Program, which is modiÞed with the Program Editor.
The Program Editor spans several display pages, which can be viewed by using the
soft buttons (the ones labeled
<more>
.
Envelope
An aperiodic modiÞer. In other words, a way to cause a sound to change over time
without repeating the change (unlike periodic modiÞers like LFOs, which repeat at
regular intervals).
File
A group of objects stored to a ßoppy or hard disk, or loaded into the K2600Õs RAM
from disk.
Global
In this manual, used primarily in reference to control sources. A global control source
affects all notes in a layer uniformly. If a layer uses a global control source, that control
source begins to run as soon as the program containing it is selected. Its effect on each
note will be completely in phase, regardless how many notes are being played.
Compare Local.
Hard Reset
Resets all parameter values to their defaults, and completely erases the contents of
RAM. Press the Reset button in Master mode to do a hard reset. This is a quick way to
restore the factory defaults to your K2600, but
everything
in RAM (all the objects
youÕve created) will be erased, so objects you wish to keep should be saved to disk or
SyxEx dump. A hard reset should not be used to recover if your K2600 is hung up,
except as a last resort. See Soft Reset.
KB3 Program
Uses oscillators to emulate tone wheel organs. DoesnÕt use VAST processing; no
layers, keymaps, or algorithms. Requires a special channel called the KB3 channel.
Keymap
A keymap is a collection of samples assigned to speciÞc notes and attack velocities.
Keymaps usually contain numerous sample roots pitch-shifted across a range of
several notes. When you trigger a note, the keymap tells the K2600 what sound to
play, at what pitch, and at what loudness.
To Next Page
Loading...
Need help?
General
