12
Installing Kurzweil K2600 ROM Options
Sound Check
17. Check the confirmation page to make sure you’ve selected the right file, then press OK.
When the installation is finished, the Drive Selection page reappears.
18. Repeat Steps 15–17 for each of the remaining files in your list (inserting disks as necessary
if you’re installing from floppy disks).
19. When all the files are installed, press Done. The K2600 displays the message
Finishing|installation|of|ROM|objects. When the installation is complete, the
main Boot Loader page reappears.
20. Select the Hard|Reset option, then press OK (a hard reset is necessary to reinitialize all
objects). You’ll see a warning reminding you that a hard reset will delete all user RAM (all
of the objects that you’ve created). Press the Up and Down cursor buttons at the same
time to execute the hard reset. You’ll see a message informing you that user RAM has been
erased. Press any button, and you’ll return to the main Boot Loader page. Select the
Run|System option, then press OK. After a few system checks, the K2600 will return to
Program mode.
Caution: Be sure to do the hard reset! It ensures that all the ROM objects are available and
ready to play.
Congratulations! Your option installation is complete.
Sound Check
Reconnect your K2600 to your audio system, or plug in a set of headphones. Check your audio
levels. Scroll through the program banks to find the new programs. Play a few of the programs
to make sure that everything is working properly. The programs are in the following locations:
Base ROM Sounds 001–199
Orchestral option 900–999
Contemporary option 800–899
SD Piano option 720–729
Live mode 740–749
Vintage EPs 600–699
General MIDI 500–635 (1–128 in GM Mode)
To Next Page
Loading...
