Need help?Do you have a question about the Kustom Signals Raptor RP-1 and is the answer not in the manual?
General| Brand | Kustom Signals |
|---|---|
| Model | Raptor RP-1 |
| Category | Radar |
| Language | English |
Details general specifications like type, frequency, system accuracy, and operating voltage.
Details speed ranges for stationary and moving modes, and target sensitivity.
Details the functions of buttons A, B, C, D, E, F on both wired and wireless remote controls.
Outlines the importance of tuning fork tests at shift start/end for accuracy and functionality.
Describes the unit's power-on sequence, internal tests, and how results are displayed.
Explains automatic self-tests and how to perform manual display and internal tests.
Details how to use tuning forks to simulate targets and test radar accuracy in different modes.
Step-by-step guide for conducting tuning fork tests in stationary mode.
Instructions for testing accuracy using tuning forks in the moving opposite direction mode.
Details how to conduct tuning fork tests in the moving same direction mode.
Provides checks and solutions if tuning fork tests do not yield proper speed readings.
Steps to synchronize the radar with the vehicle's speedometer for accurate operation.
Describes the six stationary modes: ALL, Approaching Only, and Receding Only for both antennas.
Guides on completing a tracking history, listening to audio pitch, and locking target speeds.
Explains how to lock a target's speed and the behavior of the unit when locked.
Guides on setting up and operating the unit in moving mode, opposite direction.
Details how to lock target and patrol speeds in moving mode.
Guides on operating the unit in moving mode, same direction, including speed difference logic.
Explains VSS integration and how it steers the DSP for target search.
Covers shadowing, combined speeds, and interference from other sources like radio transmitters.
Explains the importance of groundspeed in moving radar and how to maintain/verify it.
Provides a list of common problems and their possible solutions before returning the unit.
Addresses issues like no power indication and test cycle errors or failures.
Solutions for no target readings in stationary mode and no patrol speed in moving mode.
Covers issues with moving mode target readings, speedometer sync errors, and short range.
Explains how to enter and operate the TEST mode, indicated by "FORK TEST".
Details how to operate in moving opposite mode, including fastest target display.
Explains operation in same direction mode, including automatic detection of speed differences.
Describes how to lock the fastest target speed and the resulting display indicators.
To Next Page
