Kustom Signals Eagle 3 User Manual

S1
- Press to enter Menus. In Menus, pressing
increments Menu screens.
S2
- Initiates the display, internal and tuning fork
tests. In
Menus, pressing will save selection and
return
to Main Enforcement screen.
S3
- Programmable soft key short cut to favorite
menu.
Toggles Patrol Speed Blanking with a
locked target.
S4
- Control for power on / off.
Power off to save
current menu selections.
Eagle 3 Quick Reference Guide
North Carolina
1 Eagle 3 Front Panel Controls
www.kustomsignals.com
Sales (800) 4KUSTOM (800) 458-7866
Customer Service (800) 835-0156
Eagle 3 Quick Reference Guide
KSI Part # 006-1003-11 Rev 1
4
Eagle 3 Fork Test
Stationary Tuning Fork Test
1. Place the Eagle 3 in stationary mode, select Front antenna.
2. Press the Test button or touch screen lower right.
3. Lightly strike the low fork (30 mph) and place in front of the
antenna. Verify the speed displayed is ± 1 mph.
4. Repeat for the high fork and rear antenna (if used.)
Moving Mode Tuning Fork Tests
1. Place in the Moving Opposite mode, select Front antenna.
2. Press the Test button or touch screen lower right.
3. Lightly strike the low fork (30 mph) and place in front of the
antenna. Verify the Patrol speed displayed is ± 1 mph.
4. While holding the lower speed fork in front of the antenna,
lightly strike the high fork (55 mph) and place in front of the
antenna. Verify the Target speed displayed is the difference
between forks (25 mph) with a tolerance of ± 1 mph.
5. Repeat for Same direction with the High, then Low forks.
6. Verify the speed is the sum of the forks (85) ± 1 mph.
7. Repeat for the rear antenna (if used.)

Kustom Signals Eagle 3 Specifications

General

Brand	Kustom Signals
Model	Eagle 3
Category	Radar
Language	English

Summary

Eagle 3 Fork Testing Procedures

Stationary Tuning Fork Test

Step-by-step guide for stationary tuning fork tests with Eagle 3.

Moving Mode Tuning Fork Tests

Procedures for tuning fork tests in moving modes (Opposite/Same Direction).

Eagle 3 Front Panel Controls

Front Panel Button Functions

Explains the functions of S1, S2, S3, and S4 buttons for device operation.

Eagle 3 Remote Control Operation

Remote Control Button Functions

Details the functions of each button (A-J) on the Eagle 3 remote.

Eagle 3 Touch Screen Controls

Touch Screen Pad Functions

Explains the functions of touch screen control pads A through G for operation.