KYMCO DINK 200i Service Manual

1. GENERAL INFORMATION
1-11
DINK200i/125
SPECIAL TOOLS
Tool Name Tool No.
Illustration
(Note: the special tools may differ
slightly from those shown in the
figure of this manual.)
Flywheel puller
(Refer to the “STARTER
CLUTCH” section in the chapter
10.)
A120E00003
Oil seal and bearing
installer
A120E00014
Universal holder
(Refer to the “DRIVE PULLEY,
DRIVE BELT AND DRIVEN
PULLEY” section in the chapter
8.)
A120E00017
Flywheel holder
(Refer to the “STARTER
CLUTCH” section in the chapter
10.)
A120E00021
Clutch spring compressor
(Refer to the “DRIVE PULLEY,
DRIVE BELT AND DRIVEN
PULLEY” section in the chapter
8.)
A120E00034
Valve adjuster
(Refer to the “VALVE
CLEARANCE” section in the
chapter 3.)
A120E00036
(Cont’d)

KYMCO DINK 200i Specifications

General

Displacement	175.1 cc
Cooling System	Liquid cooled
Transmission	CVT
Front Suspension	Telescopic fork
Front Brake	Disc
Rear Brake	Disc
Seat Height	780 mm
Dry Weight	148 kg
Front Tire	120/70-12
Rear Tire	130/70-12
Starter	Electric
Length	2050 mm
Engine Type	Single cylinder, 4-stroke
Fuel System	Electronic Fuel Injection