39
(3)
(1)
Preparing the battery charger
Plug the mains cable plug (1) into the jack socket (2) on the
battery charger.
Charging the batteries
Switch the Scooter off.
Engage the engaging lever for push mode into the
“drive“ position.
Switching off
It is imperative that you observe the sequence for
connecting and disconnecting the battery charger.
The jack socket (3) for connecting the battery charger is
located on the front of the tiller.
(1.) Connect the battery charger plug (4)
to the Scooter charging socket.
To Next Page
Loading...
