35
Pushing the scooter
(2)
In order to be able to push the Scooter, you
must disengage the drive motor.
The disengaging lever (1) is located on the
bottom right-hand side of the Scooter.
No one is permitted to sit on the Scooter when
it is being pushed.
= Pushing (a):
Switch off the Scooter.
Pull the engaging lever (1) upwards as far as
the stop (limit position).
= Driving (b):
Push the engaging lever (1) downwards as far
as the stop (limit position).
NOTES:
1.Always switch the Scooter off to push it.
2.If a pre-set speed is exceeded while you are
pushing the Scooter, the drive motor will
switch on automatically and brake the scooter
To Next Page
Loading...
