8-12
H. Remove the oil filter cartridge (3) with an oil cartridge
wrench.
I. Apply a light coat of clean engine oil to the O-ring (4) of
the new oil filter cartridge.
NOTE
An oil cartridge wrench is available at a nearby KYMCO dealer
NOTE
Make sure the O-ring is seated properly.
J. Install the new oil filter cartridge with an oil cartridge
wrench, and then tighten it to the specified torque.
Tightening Torque
Oil filter cartridge 10 N-m (1 kgf-m, 7.2 lbf-ft)
To Next Page
