10. A.C. GENERATOR/STARTER CLUTCH
10-8
People GT 200i
Install the starter idle gear and shaft.
Install the starter driven gear onto the
crankshaft.
FLYWHEEL INSTALLATION
Install the flywheel onto the crankshaft by
aligning
the key on the crankshaft with the
groove in the flywheel.
Install washer and nut.
Hold the flywheel with the flywheel holder
and tighten the flywheel nut.
Torque: 5.5~6.5 kgf-m (58.8 N-m)
Remove the flywheel nut and washer.
Flywheel holder E021
Fl
• Before installation, check and make
sure that the inside of the flywheel is
not contaminated.
＊
Special
Shaft
Starter Driven Gea
To Next Page
Loading...
Need help?
General