MA2000w & PA2000w Setup Quick Guide 6
Step 1
If your router supports WPS, you can
configure network connection using the WPS
push button on your router. Check your router
manual to WPS support.
1. Turn on the computer.
2. Press Wireless Network ( ) on the
operation panel of the machine. The
wireless network indicator flashes.
3. Press the WPS button on the router.
Wireless Setup for
MAC (WPS)
Before setting up printer you first must,
download the Mac Driver from Kyocera.info
and run the installer. This will install all
software required.
4. The network between this machine
and the router is being configured. If
the network connection between this
machine and the router completes,
Wireless Network ( ) will light up.
5. Print a Status page.
+ Press and hold the Mode Select key for
3 seconds.
+ The attention light will start flashing and
status page will be printed.