Need help?Do you have a question about the Kyosho Concept 30 SR-X and is the answer not in the manual?
Emphasizes the model is not a toy and requires careful assembly and operation.
Lists essential equipment and components needed for helicopter operation.
Lists necessary tools not included in the kit for assembly.
Provides advice for efficient and accurate model assembly.
Steps for setting up the radio control system before flight.
Essential checks to perform before every flight for safety and performance.
Information on adjusting the main rotor pitch for optimal flight.
Details how the helicopter moves in response to transmitter stick commands.
Illustrates standard transmitter stick positions for operation.
Essential checks and procedures to perform before starting the engine.
Step-by-step guide for starting the helicopter engine.
Safe procedures for shutting down the engine after use.
Solutions for common problems encountered during engine start-up.
Instructions for adjusting main rotor blade tracking for balanced flight.
Explains trim adjustment for correcting helicopter tilt and drift.
Guide to adjusting trims based on helicopter tilt tendencies.
Safety guidelines for practicing hovering.
Advice to keep initial hovering flights at low altitudes.
Instructions for attaching a safety bar to prevent tipping.
How to practice keeping the helicopter stationary.
Instructions for performing circular flight maneuvers.
General guidance on landing the helicopter safely.
Procedure for performing an autorotation landing in emergencies.
Troubleshooting steps when the helicopter fails to lift off the ground.
Diagnosing and fixing issues with main rotor blade tracking.
Identifying and resolving causes of severe helicopter vibration.
Addressing common problems related to the clutch system.
Troubleshooting steps for unresponsive rudder control.
Diagnosing and fixing problems with the swashplate assembly.
Steps for removing and replacing the helicopter's engine unit.
Procedure for replacing the counter gear assembly.
How to adjust the backlash between the main and pinion gears.
Procedure for removing and replacing the swashplate assembly.
Instructions for adjusting the position of the mast stopper.
How to replace the shaft guides on the helicopter.
Diagram showing exploded parts of the main rotor and grip assembly.
Diagram showing exploded parts of the frame and gear train.
Diagram showing exploded parts of the engine and muffler system.
Diagram showing exploded parts of the tail boom and rotor system.
Diagram showing exploded parts of the main body and canopy.
Essential checks and safety measures to perform before flight.
Procedures and safety considerations while the helicopter is in flight.
Post-flight checks and maintenance to ensure safety.
Critical safety warnings to prevent injury and damage.
To Next Page
General