Do you have a question about the Kyosho MINI-Z AWD and is the answer not in the manual?
Chassis Type | MA-020 |
---|---|
Chassis Material | Plastic |
Frequency Band | 2.4 GHz |
Drive System | AWD (All Wheel Drive) |
Motor | 130-size |
Battery | 4 x AAA |
Length | 165 mm |
Wheelbase | 90mm, 94mm, 98mm (adjustable) |
Covers crucial safety advice for assembly, operation, and product use.
Information on battery types, recycling, and proper disposal procedures.
Lists parts included in the Ready Set configuration for operation.
Lists parts included in the Chassis Set configuration, excluding body and transmitter.
Specifies the need for a compatible transmitter and receiver for the Chassis Set.
Notes the requirement for a separate body set when using the Chassis Set.
Lists necessary tools such as screwdrivers and cutters for assembly.
Identifies and explains the functions of the transmitter's controls and indicators.
Details parts of the transmitter like antenna, power switch, and steering wheel.
Identifies main parts of the chassis, such as chassis, power switch, and motor.
Shows the location of front/rear tires and battery holder on the chassis.
Instructions for installing the transmitter antenna correctly.
Guide on how to insert batteries into the transmitter for operation.
Core steps for assembling the chassis before body mounting.
Explains how to adjust the wheelbase based on the car body type.
Steps for turning on the transmitter and the model's power switch.
How to adjust throttle trim to stop the car completely.
How to check all controls by lifting tires off the ground.
Instructions on using the throttle trigger for forward, neutral, and reverse.
Tips on holding the transmitter and antenna correctly for optimal signal.
Practicing gentle throttle and steering for better control.
How to adjust steering angle (D/R) for desired response.
Suggests practicing figure 8s for better steering control.
How to change crystals for frequency selection on the transmitter.
Instructions on installing tires and wheels, including wheel nuts.
Steps for removing and installing the motor and pinion gear.
Guide on disassembling and replacing suspension limiters.
Shows how to connect various wires for servos and power to the circuit board.
Instructions for removing the receiver cover to access components.
A list of available spare parts with part numbers, diagrams, and prices.
Troubleshooting steps for when the model does not move.
Solutions for issues where the model loses steering control.
Steps to fix issues where the model pulls to one side.
Solutions for a model experiencing significantly reduced speed.