LA8_UM_EN_4-0
w w w . l - a c o u s t i c s . c o m
23
2323
23
6.4.4 Loudspeaker cabling
Enclosures can be cabled with the controller via two 4-point SpeakON
®
connectors, each of them delivering two
channels, or one 8-point CA-COM
®
connector, delivering the four channels.
The SpeakON
®
connectors are wired as follows:
Left: Pin 1+ Out 1+
Pin 1- Out 1-
Pin 2+ Out 2 +
Pin 2- Out 2 -
Right: Pin 1+ Out 3 +
Pin 1- Out 3 -
Pin 2+ Out 4 +
Pin 2- Out 4 -
The CA-COM
®
connector is wired as follows:
Pin A Out 1+
Pin B Out 1-
Pin C Out 2 +
Pin D Out 2 -
Pin E Out 3 +
Pin F Out 3 -
Pin G Out 4 +
Pin H Out 4 -
Figure 13: Output speakers connections (signal path)
The 8-point CA-COM
®
connector on the LA8 is fully compatible with all 8-point L-ACOUSTICS PA-
COM
®
cables EXCEPT for the DO2W, DOFILL and DOSUB cables.
Refer to LA8 PACOM CABLES Technical bulletin [3.4] for more details.
Before connecting a loudspeaker system, refer to the applicable User manual [3.4] for further
instructions.
To ensure both high performance and safety L-ACOUSTICS
recommends the exclusive use of high-
quality, fully insulated speaker cables made of stranded copper wire.
In order to preserve a high damping factor it is desirable to keep loudspeaker cables as short as possible
and with a gauge offering low resistance per unit length.
To Next Page
